Specs
Toolroom Lathe specs
Setup notes and briefing numbers for Toolroom Lathe.
Key dimensions before spindle start-up
The Toolroom Lathe specs page brings together the dimensions and operating details buyers check first. It gives a clean reference for swing, centres, spindle information and other selection points.
Toolroom lathe buyers usually begin with swing over bed, distance between centres, spindle bore and speed range. On jobs around Johannesburg, those figures decide whether the machine will handle shafts, bushes, threaded parts or small repair batches without extra setup compromises. If taper turning, fine feed control or close tolerance facing matters, the apron and gearbox details belong in the first check.
A proper spec review should include bed condition, cross slide travel and tailstock movement, not only headline capacity. Look for notes on chuck size, motor rating and electrical supply so the machine suits the workshop power available. Wear near the headstock end can affect finish quality long before a machine looks rough in photos.
Lathe checks that affect purchase
For a used toolroom lathe, buyers normally want spindle nose type, taper sizes and feed thread charts confirmed against the machine itself. Metric and imperial threading capability matters where repair work covers mixed older equipment. A machine with steady rests, change gears or a coolant system can alter how soon it fits into daily turning work.
Before using the contact form, note the swing and length you need and any must-have accessories such as a 3 jaw chuck, 4 jaw chuck or fixed steady. Include whether the machine is for maintenance turning, toolroom work or short production runs. That makes it easier to match the enquiry to the right type of lathe and available specification details.
- Swing, centres and spindle bore
- Feeds, threads and speed steps
- Chuck, steadies and tailstock tooling
Site conditions that affect lathe checks
In Crown Mines and wider Johannesburg, transport access, loading method and machine footprint matter before a lathe is moved into place. A toolroom lathe may need levelling space, correct voltage and enough room for long bar or shaft work at the headstock end. Buyers should also check whether guarding, coolant trays and loose tooling are included with the machine on site.
Dust in inland workshops can shorten the life of slides, lead screws and electrical cabinets if cleaning routines are poor. Coastal air raises the need for rust checks on bedways, chucks and bare machined surfaces. During power interruptions, confirm the control arrangement is straightforward and that restart checks are part of normal workshop practice.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
Spec points worth writing down
Record the model, centre height, bed length and spindle speeds exactly as shown on the machine plate or listing. Add any observed backlash, missing guards or tooling included with the sale. Those notes help when comparing one toolroom lathe against another.
Keep inspection photos and any measured test cuts if accuracy is under review. A simple record of turning finish, tailstock alignment and gearbox operation is more useful than a generic machine summary. Where the lathe will cut threads regularly, note the thread chart condition and gearbox selection markings as well.
What our Metalworking Machine customers say
Verified Google reviews