Specs
Training Day specs
Machine details and key figures for Training Day.
Training handover points by machine
The Training Day specs page sets out what is covered when a machine is handed over for use on the floor. It can include the control layout, routine checks, lubrication points, safe start-up, and the basic operating steps for the lathe, boring machine, or valve grinder supplied.
Training Day specs begin with the exact machine being handed over, whether that is a lathe, boring machine or valve grinder. The sheet notes control positions, lubrication points, guard checks and the normal start-up order used in the workshop. Johannesburg dust, three-phase supply stability and the condition of belts, slides and coolant lines all affect what operators need to see on the day.
Before the first job goes on, the operator should walk around the machine with the spec sheet and identify each lever, switch and feed setting in place. A short record kept near the machine helps with spindle lubrication, coolant level checks and noting any backlash or unusual noise found during the first runs. This is especially useful where more than one shift may use the same machine over a working week.
What the handover should cover
A proper Training Day spec gives the operator the basic sequence for safe use, not just the machine nameplate details. That can include chuck or fixture checks, lubrication routine, emergency stop position, feed engagement, warm-up procedure and the correct shut-down at the end of the day. On older used machines, these notes also help distinguish normal running characteristics from faults that need attention.
Capture the exact machine details handed over with the unit, then keep the note with the service file or tool cabinet.
- Control layout noted at handover
- Lubrication points listed for daily use
- Loose accessories checked against machine
Handover points for South African workshops
Machines handed over in Crown Mines may be going straight into production, training use or maintenance work, so the spec should reflect the intended job. Dust around open ways, limited space around the machine and shared power distribution all influence what must be shown to the operator on day one. The handover note should also mention any fitted guards, coolant arrangement and the position of isolators in the workshop.
Coastal air calls for closer attention to exposed metal, way oil and storage between shifts. Inland workshops often deal with dust around slides, chucks and electrical panels, so cleaning points should be shown during handover. Power interruptions also matter, which is why safe stop and restart steps belong in the Training Day spec.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
Operator notes worth recording
Use Training Day when operators need practical handover guidance on controls, setup, lubrication and safe daily use.
Record the machine model, the controls demonstrated, the lubrication grade if known and any operating limits discussed during handover. It also helps to note chuck keys, centres, toolposts, drive belts or other loose items supplied with the machine so nothing is missed when the equipment changes hands.
What our Metalworking Machine customers say
Verified Google reviews